
A single-stage onboard charger takes out the bulk capacitor that two-stage designs rely on
(Image courtesy of Infineon)
Visteon, SHINRY and Infineon are developing a single-stage onboard charger that supports 22 kW three-phase and 19.2 kW single-phase AC charging and full vehicle-to-everything (V2X) capability without the bulk capacitors that two-stage designs depend on. The collaboration, announced at electronica in Munich, relies on Infineon’s gallium nitride (GaN) bidirectional switches to cut the semiconductor count, and the partners say the single-stage architecture improves reliability while lowering size, complexity and cost.
What a single-stage onboard charger leaves out
A conventional two-stage charger rectifies grid AC to an intermediate DC link of about 400 V to 450 V and then passes it through an isolated DC-DC converter that matches the battery. The bulky capacitor on that link buffers ripple, but it adds volume and weight, and in electrolytic versions it is a wear-out point because the electrolyte evaporates over time. A single-stage design converts AC to DC directly through a matrix topology, so there is no fixed intermediate bus and no large capacitor, only a small high-frequency filter capacitor.
Fewer switches in a single-stage onboard charger
Each Infineon device is a monolithic switch that blocks voltage and conducts current in both directions, so bidirectional switching needs fewer semiconductor components, and the partners say high-frequency operation raises power density by shrinking the magnetics. Infineon’s CoolGaN bidirectional switch family, announced in June 2024 with high-voltage 650 V and 850 V versions, puts two independently controlled gates over one shared drift region. In a single-stage onboard charger, Infineon puts the saving at four to eight discrete unidirectional switches replaced by nearly half as many monolithic packages.
From joint venture to 22 kW charger
In March 2024 Visteon and SHINRY formed the Michigan-based Visteon-Shinry Power Electronics (VSPE) joint venture to develop and industrialise power electronics. Infineon and Visteon followed in May 2025 with a memorandum of understanding on wide bandgap power conversion for EV powertrains, and that agreement named battery junction boxes, DC-DC converters and onboard chargers among the applications that could use Infineon’s CoolGaN and CoolSiC devices.
The 2026 collaboration puts Infineon’s GaN switches into a 22 kW onboard charger design, with VSPE contributing the converter topology, a proprietary control strategy and system integration expertise. Its full V2X capability covers grid interaction and energy flexibility, and VSPE co-general manager Zilai Zhao says the pairing of Visteon’s system expertise and Infineon’s GaN technology targets next-generation EV platforms.
Infineon vice president for GaN Automotive Benoit Rousseau says the switch combines switching performance and efficiency with a new level of semiconductor integration, enabling new power conversion architectures. SHINRY’s R&D team will validate the architecture against automotive reliability standards, according to chief technology officer Mark Sun, who expects pairing Infineon’s switches with the single-stage topology to improve power density and system cost.
Stay ahead in the electrification revolution. Explore more breakthroughs from leading innovators in electric commercial transport – visit our news page.
